Home Request Brochure Contact Us Site Map
Where To Buy

Lockcrete Bauer is the Retaining Wall Division for
The Bauer Company, Inc. a subsidiary of the Snyder Associated Companies, Inc. and has been the exclusive manufacturer of the Keystone Retaining Wall Products in the Tri-state region since 1995.
 
DESIGN ESTIMATOR
ESTIMATING
PLAN AHEAD

Your project will go smoothly if you begin with the proper materials. To calculate the materials required, begin by sketching out your wall including dimensions for length and height. Also take into consideration any critical conditions that may influence your wall’s geometry. Use the illustrations on the following pages as a guide to sketch out your wall. You may also want to review your sketch and measurements with your local Authorized Dealer to ensure that your estimate is as accurate as possible. To locate an Authorized Dealer near you call 1-800-419-WALL or visit our "Where-To-Buy" page.
DETERMINE YOUR WALL LAYOUT
Sample wall profile If your wall height varies, divide the wall panels into segments according to height. This will assist in effectively calculating the square footage, as well as eliminate excess materials. (See the Front View, Side View, and Overhead view drawings below).
Overhead View Sample cross section
PRODUCT ESTIMATOR

Enter Wall Length (WL) and Wall Height to determine the quantity of cap units and stacking wall units needed for your project. Total Wall Length will determine quantity of cap units. Total Square Feet of Face (SFF) will determine quantity of stacking wall units.

WALL PANEL

Panel 1

Sidewall A

Sidewall B

Panel 2

Panel 3

aaaWALL LENGTH aaaaaWALL HEIGHT

*

*

*

*

* =
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa TOTAL SFF
aa aaTOTAL WL

BUILDING TERRACES
Terraces are a pleasing way to build a taller retaining wall. Closely spaced terraces need to be reviewed by a qualified engineer to determine overall stability. Terraced walls should be analyzed as a complete wall system versus an individual wall, unless they are spread greater than twice the wall height of the lower or first wall and the soils are free draining and granular in nature.
IDENTIFY ANY CRITICAL CONDITIONS
Surcharge Load: Backslope Angle: Foreslope Angle Drainage/Water Conditions:
The load imposed on the soil behind the wall which exerts an additional force on the wall structure. The angle from the top of your wall to the top of your slope at the finished grade. Foreslope Angle: The angle from the bottom of your wall, not including embedment, to the finished grade. Water Conditions: The presence of water is a significant factor in designing segmented retaining walls.
 
Using your dimensions determine your square feet of face area by multiplying the wall length by the wall height. Remember to panelize your wall if your project has varying wall heights. Once you have a total SFF area you can estimate the total number of block you will need. The number of caps required can be determined by the overall length of the wall. Use the "How To" information on the Rear Lip, Pinned System or Country Manor pages, to complete a preliminary product estimate.
ASSESSING WALL PERFORMANCE Wall embedment when building on slopes.
Descending slopes, as illustrated at right, are a critical condition, and should be reviewed by a qualified engineer prior to construction
CONTACT YOUR LOCAL AUTHORIZED DEALER
After you have completed your sketch, and selected a product type, take your measurements to your local Authorized Dealer. They can assist you in preparing a final product estimate for your project. Additionally most Authorized Dealers have displays at their yard to assist you with product and color selection
 
Lockcrete Bauer
119 Ruth Hill Road
Worthington, PA 16262
Phone: 1-800-419-WALL
Fax: 724-297-5083
www.lockcretebauer.com
© 2009 Lockcrete Bauer